Ensure that the sketch is fully constrained.

On it, draw three construction lines and a three point arc. Using what you just learned, start a new sketch on the top of the model. (Figure Step 16A and 16B) Figure Step 16A Figure Step 16B Step 17 (Figure Step 15) Figure Step 15 Step 16Įxtrude the sketch. Using the CREATE CONSTRAIN command, apply the Tangent constraint to the arc and the top edge. (Figure Step 14A, 14B, and 14C) Figure Step 14A Figure Step 14B Figure Step 14C Step 15 For the third point, snap it to the midpoint of the top edge. Snap the first point to one end of the construction line, snap the second point to the other end of the construction line. Step 14Ĭlick the THREE POINT ARC command. Draw the line, using the LINE command, constrain it perpendicular to one of the edges. (Figure Step 12) Figure Step 12ĪUTHOR’S COMMENTS: Do not offset an edge. Using what you already learned, open the Application Options dialogue box. Start a new sketch on the right side face as shown in the figure. On some sketches, it is sometimes easier to draw without the grid getting in the way. To the more experienced operator, grid display can be disabled in Sketch mode. Up to this point in the Inventor book, the grid display has been enabled in Sketch mode. (Figure Step 8) Figure Step 8 Sketching Without the Grid All of the lines in the sketch should appear purple. Press F6 to change the view to the Home view.

Trim and dimension the sketch ensuring that it is totally constrained. Offset all four lines as shown in the figure. Step 5ĭraw the four outside lines of the Base sketch. Project the Center Point onto the sketch. Start the Base sketch on the Front or XZ plane. (Figure Step 3A, 3B, 3C, and 3D) Figure Step 3Aĭimensioned Multiview Drawing Figure Step 3Bĭimensioned Detail Drawing Figure Step 3CģD Model – Home View Figure Step 3DģD Model – Rotated View Step 4 Save the file with the name: Inventor Workalong 18-1. Using the NEW command, start a new part file using the template: English-Modules Part (in).ipt. WORK ALONG: Drawing a Solid Model with Arcs and Rectangles Step 1Ĭheck the current project and if necessary, set it to Inventor Course.

Autodesk inventor tutorial no sound